Create 14 Rings With PamReily DIY Image Under Glass Ring Kit Including Adjustable Rings

This Stuff is Free Too:

FREE

Pam

would you please upload a photo of a ring you have made from these parts, so we can get a better idea of what they look like when finished? also, does it come with printed directions?

Aug 30th, 2012 at 4:35:00 PM PDT by

That would look like the rings were included, and since they aren't, I don't want to do that. If you look at my feedback there are MULTIPLE examples of these rings to look at. :)

No, it doesn't come with directions. But...

The basics of image under glass: make sure the glass is clean (I wipe all the pieces with an old piece of towel, gets off fingerprints and such) then put a small amount of the DG3 on the bottom, turn over and place where you want it on the paper. If there is enough glue, it will spread evenly and squish out the sides a small amount (this helps seal the edges). If there is not enough glue, there will be air bubbles or other disconnected spots...just carefully peel the paper back off (right then) and add another dot of glue. It's a tiny learning curve to get the right amount but once you do it's the easiest craft on earth.

Depending on humidity, it could take as little as a few hours for the DG3 to cure/dry, but I always leave them at least 24 hours before trimming away the excess paper. When dry and trimmed, brush a coat or two of mod podge on the back to seal the paper (give it a few hours to get dry before proceeding). If using a pendant tray, you can use a little dab (very little is needed) to glue the cab into the tray. With the pieces that people can see the back of the cab on, like rings and pendants made with the leaf bails, I put a layer of decorative paper on the back, so people are not looking at the back of the stamps or whatever...hope that makes sense!

Aug 30th, 2012 at 4:45:40 PM PDT by